安達儀器PCB線路板全自動取樣機AD668
Model No.型號：AD668
Automatic specimen cutting machine for micro section
印制線路板金相切片取樣機（全自動）
Application:PCB factory physical laboratory Metallurgical sample cutting (bare board)
適用范圍：PCB 廠金相實驗室取樣用。（適用于覆銅板即沒有裝配元件的 PCB 板）
Technical parameters技術參數：
1.Max sample cutting size取樣尺寸: L*W*H=50*50*8mm
2.Min Sample cutting size小取樣尺寸: 5*5*8mm
3.Sample size:can be set according to customer requirement (normal size is 20*15mm)
樣品尺寸: 可根據客戶要求設定（一般為20*15mm）
4.Max board size: 16”*24” (can take sample at any place of the board)
臺面尺寸16*24"（能取到PCB 板的任何位置）喉深：28cm
5.Machine spindle spec: 25000r/min/220V/50Hz
取樣機主軸：25000r/min/220V/50Hz
6.Machine router spec:1/8” (can change router size according your requirement, but we recommend size is 2.0mm )
取樣機鑼刀：1/8”（自由更換鑼刀，推薦2.0mm）
7.Router stepping in a method: when the setting is finished, the router gets inside automatically, and when therouting finished, the router automatically go out.
進刀方式：設定好取樣尺寸后自動進刀，直至切片被*取出
8. Machine is equipped withvacuum cleaner.
取樣機配備吸塵器
9.Machine dimension： 680*530*1200mm
取樣機外形：長×寬×高=680×530×1200mm
10.Laser positioningto make it precise.
紅外燈定位
11.PLCprogramming controlling
PLC 程序設計控制
12. Need air supply，air tube dia 8mm
啟動需要?dú)庠矗瑲夤苤睆?mm
13. The sampling machine uses drilling and milling, to avoid sample deformation, to ensure test accuracy
該取樣機采用鉆銑方式，避免了樣片變形，保證測試準確度
