型號描述
8010 型 INLINE 流量開關，用于監控純凈的、與水類似的液體，所監控的液體中不能含有可被磁化的顆粒。開關由一個接頭 (S010) 和一個電子設備模塊 (SE10) 構成，通過一個卡口接頭可以將兩者快速、簡單地相連。設備通過轉接電子設備模塊中所包含的簧片開關顯示是否存在流量?？舍槍f增和遞減的流動速度，通過一個位于電子設備模塊上的調整螺栓在特定的范圍內對“最小/”開關點進行調整?？商峁﹥煞N SE10 電子設備模塊：- 無流量打開 (NO)：流量會將觸點閉合。- 無流量關閉 (NC)：流量會將觸點打開。該 S010 接頭帶有不同的接口，具有兩種結構方式可用：- 帶有一個小葉輪 ?區域 1? 適合接頭 DN15 至 40。- 帶有一個大葉輪 ?區域 2? 適合接頭 DN32 至 50。
1）以低成本集成到管道系統中，不需額外的配管
2）磁性測量原理
3）通過調節螺栓簡便地設置開關點
Type Description
The INLINE flow sensor/switch Type 8010 is specially designed for use in pure and water resembling fluids, free from air bubbles and magnetizable particles, to monitor minimum/ maximum values of flow. The sensor/switch is made up of a fitting (Type S010) and an electronic module (Type SE10), quickly and easily connected together by a Quarter-Turn. This device indicates the presence of a flow in the pipe by switching the Reed contact contained in the electronic module. The switching points Min./Max. for rising and falling velocities can be set with a screw within a defined range. The SE10 electronic module is available in two version: -Normally open (NO): The flow switches on the contact. - Normally closed (NC): The flow switches off the contact. These S010 fittings are available in two versions: - with a short blade ?Range1? fitted for the fittings DN15 to 40. - with a long blade ?Range2“ fitted for the fittings DN32 to 50.
1）Economic integration in pipe systems without any additional piping
2）Magnetic measuring principle
3）Mechanical adjustment of setpoint
