高壓交聯聚乙烯絕緣電力電纜
HIGH-VOLTAGE XLPE INSULATED POWER CABLE
執行標準
IMPLEMENTED STANDARD
額定電壓35kV及以下銅芯、鋁芯交聯聚乙烯絕緣電力電纜GB/T12706.2-2002,GB/T12706.3-2002,IEC60502-1997
Rated voltage 35kVand below XLPE insulated,Cu/Al corepower cable GB/T12706.2-2002,GB/T12706.3-2002,IEC60502-1997
產品用途
APPLICATION
本產品適用于額定電壓3~35kV的高壓電力線路輸配電能。
The product applies to transmission and distributionof highvoltage power lines at rated voltage3-35kV
使用特性
SERVICE CHARACTERISTICS
電纜導體的額定溫度為90℃,短路時(最長持續時間不超過5S),電纜導體的溫度不超過250℃。
敷設電纜時的環境溫度應不低于0℃,低于0℃時應先預熱。
敷設電纜時允許彎曲半徑:單芯電纜不小于電纜外徑20倍;多芯電纜不小于電纜外徑的15倍。
Rate voltage max is 90℃.at short circuit (duration max ≤5S) ,temperature max is not higher than 250℃.
The temperature of laying should not be lower than 0℃ , pre-heating is needed if the ambient temp.of laying is lower thano℃.
The bend radius for laying: the one of single core cable shouldnot be shorter than twenty times of outer diam; the one of mu-lti core should not be shorter than fifteen times of outer diam.