9180數字顯示控制器
高度準確的2個最小和峰值顯示，RS232或RS485，TARA和HOLD功能，可選：功能強大的PC軟件，用于收集和處理測量數據
-
Features
- 最多可以保存8個傳感器參數（選配）
- 適用于應變傳感器進行力，壓力或扭矩測量
- 適用電位計或DC/DC傳感器進行位置或角度測量
- 模擬量信號輸出 10 V，0（4）... 20 mA（選配）
- 最小或峰值可附助顯示
- Tare去皮和hold功能
- 最多生成4個極限信號（選配）
- RS232或RS485通訊接口（選配）
- 模擬或BCD輸出（選配）
- 測量精度<0.1％
- 可使用示教程序或直接輸入傳感器數據進行縮放
- 便捷的配置和評估軟件DigiVision
-
Description
Model 9180 supports force, pressure and torque sensors operating on the strain gauge principle, as well as the connection of position and angle sensors in potentiometer or DC/DC configuration. It also allows the measurement of process signals ± 1 V/ 5 V/ 10 V or 0 ...1 mA, 0(4) ... 20 mA. The current measured value is indicated on the 14 mm high LED main display, while a second display located directly below provides a reading of the peak value.
The display is particularly suitable for highly accurate measurements due to the high accuracy of 0.1%. It is also possible to monitor up to 4 limit values and provide the results via relay or transistor outputs. Thus the process value display can be used for classification, process and control tasks. The current measured value is frozen on the display by activating an external HOLD signal. The TARE function is useful for balancing out previous loads for example. The optional serial interface can be used to transfer measured values and perform device settings. Powerful PC software is available for this on request.
State-of-the-art microprocessor technology has allowed the realization of numerous special functions for practical use. Menu guidance of device setup is standard. Selfexplanatory abbreviations greatly facilitate this process so that even inexperienced users can manage without operating instructions. First, the user specifies the type of input signal or sensor. Strain gauge, potentiometer or process signals 0 ...1 mA, 4 ...20 mA or ± 1 V, ± 10 V as well as DC/ DC sensors can be selected. Then the calibration process is selected. Users can choose between teach-in or calibration depending on the sensor protocol. The decimal point can be moved as required. The sensor excitation stated in the technical specifications is set automatically upon selection of the sensor type except with process signals. A choice of three excitations is available for process signals. Complete electrical isolation of the measurement channel prevents measurement values from being falsified by ground loops.
-
Downloads
Data sheet
9180資料參數 英 -
LINKS & CAD DATA
